Procedure to keep in mind when applying 3 types of moisturizing masks to beautiful and healthy skin from the inside

With any mask, the general rule is that you need to clean your face, exfoliate and steam 1-2 times a week to deep clean your pores.

Mask paper

Step 1

You can put the mask in the refrigerator for an hour before applying it to cool the mask. Take the sheet mask sheet out of the bag, apply it gently on the face. Spread the mask evenly, flat and close to the skin surface.

Note to avoid covering the eye area because the thickness of the skin in the eyes is only 1/4 of normal skin and is especially sensitive, requiring special care.

Step 2

Set the clock for 15-20 minutes. Applying the mask for longer than the time in the instructions for use cannot help the skin absorb more nutrients. When the mask is dry, it can cause reverse moisture absorption, causing the skin to lose water.

Step 3

Gently massage your face with your fingertips or a quartz or jade roller to help the skin absorb nutrients from the mask better. In the meantime, you can use the remaining essence in the mask bag to massage your neck, shoulders and hands.

Step 4

Remove the mask. The mask should not be removed too quickly, but should be removed slowly to avoid damage because the paper mask has adhered to the skin.

Step 5

After removing the mask, if you find the essence in the mask absorbed quickly, gently massage the skin to absorb it completely, no need to rinse. However, if the nutrients do not absorb completely and overload the skin with moisture, do not wash your face again with water. You can use mineral spray or cotton pad soaked in toner to wipe away excess essence.

Wash off mask

Step 1

Apply a layer of mask evenly all over the face, avoiding the thin and thick spots to promote the nutrients evenly on all skin areas. Do not apply to skin near eyes. You can apply multimasking method (each area of ​​skin applies a different mask) to meet multiple skin needs at the same time.

Step 2

A moist sheet mask can be applied to lock in moisture and nutrients, increasing product effectiveness.

Whether you use your hands, brush, spoon or any other tool to take out the mask and apply it to your skin, you must ensure maximum hygiene to avoid the product becoming contaminated.

Step 3

After 15-20 minutes (depending on the instructions for use of the mask), wash your face with warm water to remove the product and then rinse with cold water for toned skin.

Step 4

Start your regular moisturizing steps right away to lock in and store the mask's nutrients.

Sleeping mask

- Instant moisture: Apply a thick layer of the sleeping mask on the skin for 15-20 minutes and then rinse with water. Skin will be bright and moisturized immediately. This method helps to keep your foundation makeup moist and smooth.

- Nourish skin throughout the night: You apply the cream all over the face in a clockwise direction, apply from the inside out and gently massage the areas around the eyes and mouth to reduce fine lines. Do not rinse, but leave the mask on the skin overnight.